HEX ezCAN II Accessory Manager / 790, 890, 1050, 1090, 1190, 1290
The new generation of HEX ezCAN - an accessory manager for motorcycles which enables you to seamlessly add various aftermarket accessories such as additional lights, air horns, GPS, heated jacket and a phone charger with ease and without cutting any wires or voiding your warranty.
Customize your bike and make it safer to ride.
*Optional Up-Down Switch is available to enable further control of Aux Lights on the move (toggle on/off and brightness control) for 790(without Euro5 connector), 1050, 1090, 1190, 1290 up through '20.
Partial support for KTM 790 & 890 models.
- Any auxiliary brake light that you add to the back of the bike will only activate with the front brake lever. Not a big deal since most of us are always using the front brake to stop, but the rear brake pedal will not activate any added brake light.
- No function for toggling aux driving lights on/off with oem switches. You can still hook up aux lights to the ezCAN for a clean installation without splicing wires, and with the ezCAN software you can program seperate brightness levels for aux lights during high beam and low beam operation, but you can't switch them on/off with your stock OEM switches like you can on other models.
- No function to flash aux driving lights or have them go off when the turn signals are active.
- No integration or control over tail/brake/turn signal functions. These lights will only function normally
Key Features
- One device manages everything
- Integrates additional safety features
- Does not void warranty
- Plugs directly into CAN-Bus (saves installation time and wiring complexity)
- Unobtrusive - fits perfectly under the seat
- Easy configuration of software via USB (Mac and Windows PC)
- Four individually electronically fused channels
- Waterproof and dust-proof
Specifications and Components:
- Waterproof micro USB connector
- Battery connection and fuse
- Two CAN-Bus connectors
- Four high-power outputs (10AMP continuous / 25AMP, max 20 seconds in rush current)
- Weight 358 g (12 oz)
- Product size 55 x 30 x 16mm (2.2 " x 1.2" x 0.6")
- Download and install the HEX ezCAN software
- Install the ezCAN under the seat (Velcro included)
- Route and connect the ezCAN battery cables
- Plug the ezCAN into the motorcycle CAN-Bus
- Plug accessories into the ezCAN
- Use the software to configure the ezCAN via USB (Mac or Windows PC Software)
Software:
The HEX ezCAN software is available for both Mac and Windows PC and is used via a micro USB cable, which is included in the package.
Use Channel Mapping to select your preferred configuration. The Configuration window then lets you customize the behavior of your accessories according to CAN-Bus inputs, for example setting up an emergency brake light to flash when the ezCAN detects harsh deceleration or the LEDs to flash when the air horn is activated. Accessory/Ignition supply can be set to remain on for a specific time after the ignition is turned off.
Contents of Package:
- 1 x ezCAN Device
- 1 x Euro 5 Harness
- 1 x HEX Rubber Plug
- 1 x Micro USB Cable
- 4 x Two-wire stub connectors (Orange)
- 4 x One-wire Terminal wires (Orange)
- 4 x Blanking seals
- 3 x Blanking Plugs
- 20 x Cable Ties